Axess Ready CM-1115-RT-AR Installation Guide download pdf (Page 12)

CM-1115(20)-RT-AR User Manual

Page 11

VI. Web Server

The Axess Ready web interface provides the easiest means of operating the outlet and changing

configuration parameters.

To access the web interface, open a web browser and enter the IP address of the AR into the

address bar. The factory default IP address is 192.168.1.254.

Password

The AR uses two username/password credential sets, one for normal power control (user) and

one that also provides access to the Setup functions (admin).

Default credentials:

Role

Username (fixed)

Password (user set)

Administrator

admin

User

user

Enter a valid username and password when prompted. When the

proper username/password combination is received, the Control and

Status Page is displayed.

Control and Status Page

Once a user is validated, the Control and Status page is displayed.

Note: Only one user may be logged in to the AR at a time.

Press “Power On” or “Power Off” to turn the AC output On or Off.

In the event of a power outage, the AC output will return to its last

known state prior to the outage.

Press “Cycle Power” to temporarily change the state of the AC

output for a specified cycle time (factory default is 10 seconds).

The cycle operation performed will either be On-Off-On or Off-On-

Off, depending on the initial state of the AC output. During the power cycle operation, the Power

Status bar will indicate the temporary status with a Blue background. Once the cycle is complete,

the status bar will revert to its original condition. To abort a power cycle, press either “Power On” or

“Power Off” and the outlets will assume that status.

If the AutoPing feature is in use, this page will also display the current status (OK or Failed) for

each AutoPing, a counter of how many times the ping failed, and a counter of how many times the

defined action was triggered. Reset buttons for the Fail and Trigger counters are available for the

admin login.

Use the Refresh button to update the page with the most current status. Use of the browser’s

refresh button may lead to inadvertent power switching. If an NTP time server is being used, the

time of the last refresh will be displayed in the upper right corner.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

No comments

Axess Ready CM-1115-RT-AR Installation Guide Page 12